Wilson Electronics 812201 Guía de instalación descargar pdf (Pagina 8)

Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660

or email: [email protected]. Hours: 7 am to 6 pm MST.

Powering up a Wilson Electronics Signal Booster In-Building/In-Vehicle

For In-Vehicle, first connect the power

cable to the Signal Booster input marked

“DC 12 V IN” and then insert the large end

into a 12 V DC power socket or vehicle

power adapter.

The Signal Booster may remain on all the

time; however, leaving the Signal Booster

on in a vehicle when it is not running can

discharge the battery in a day or two.

A good option is to power the Signal Booster

through the ignition switch so that the Signal

Booster turns off and on with the vehicle.

For In-Building, first connect the optional

AC/DC power supply to the Signal Booster

input labeled “DC 12 V IN” and then into a

wall outlet.

Carefully insert the power cable.

In-vehicle 12-volt DC power supply (included)

Warning: Use only a Wilson Electronics

power supply. Use of a non-Wilson

Electronics product could damage your

equipment.

Warning: Verify that both the outside

antenna and the adapter extension

cable are connected to the Signal

Booster before powering up the Signal

Booster.

In-building AC/DC power supply (optional)

(included in the 810205 kit)

Testing a Wilson Electronics Signal Booster

To test your Signal Booster, go to a weak signal area where your cell phone registers only

1-2 bars without the Signal Booster turned on. Then, connect the Signal Booster to the

phone and you should see a signal improvement of 2 or more bars. Note: Many phones

take up to 20 seconds to reset the bar indicator.

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Wilson Electronics 812201 Guía de instalación Pagina 8