Wilson Electronics 811201 Guía de instalación descargar pdf (Pagina 12)

Signal Booster Specications

Dual-Band

800/1900 MHz Specications

Model Number / Part Number 2B1401 / 811207, 811209

Connectors FME-Male

Impedance (input/output) 50 ohms

Dimensions

5 x 5.4 x 1.4 inch or 14 x 10.8 x 3.5 cm

Weight 1.32 lbs or 0.6 kg

Frequency 824-894 MHz / 1850-1990 MHz / GSM 1575 MHz

Passband Gain (nominal)

800 MHz and 1900 MHz 20 dB

1575 MHz 8 dB

20 dB Bandwidth (nominal)

800 MHz (uplink/downlink) 50 MHz / 49 MHz

1900 MHz (uplink/downlink) 121 MHz / 94 MHz

Power output for single cell phone (uplink) 800 MHz 1900 MHz

CDMA 33 dBm

29.6 dBm

GSM 32.6 dBm 27.3 dBm

EDGE 33.1 dBm 27.8 dBm

WCDMA 33.5 dBm 29.7 dBm

Power output for single received channel

(downlink)

800 MHz 1575 MHz 1900 MHz

CDMA

9.7 dBm 13.6 dBm

GSM 8.7 dBm 9.6 dBm

EDGE 9.1 dBm 12.3 dBm

AMPS 10.3 dBm 11.9 dBm

GPS 18 dBm

Power output for multiple received

channels (downlink). The maximum

power is reduced by the number of

channels:

Number of

channels

Maximum Power

800 MHz 1900 MHz

10.1 dBm 10.9 dBm

3 6.5 dBm 7.4 dBm

4 4.0 dBm 4.9 dBm

5 2.1 dBm 2.9 dBm

6 0.5 dBm 1.4 dBm

Noise Figure (typical) 3 dB nominal

Isolation > 90 dB

Power Requirements

Signal Booster Usage

12 V, .5 A - 1.5 A (subject to uplink power)

Notes:

1. Nominal gain is the maximum gain at any frequency in the passband.

2. Nominal bandwidth is the difference between two frequencies that are adjacent to the passband where the amplication is

20 dB lower than the passband amplication. One of the frequencies is lower than the passband and the other is higher.

3. The Manufacturer’s rated output power of this equipment is for single carrier operation. For situations when multiple

carrier signals are present, the rating would have to be reduced by 3.5 dB, especially where the output signal is re-

radiated and can cause interference to adjacent band users. This power reduction is to be by means of input power or

gain reduction and not by an attenuator at the output of the device.

4. The maximum power for 2 or more simultaneous signals will be reduced by 6 dB every time the number of signals is doubled.

Part #110930 AIG - FRENCH 001 070111

3301 East Deseret Drive, St. George, UT 84790

For additional Technical Support visit www.WilsonElectronics.com

or email at: tech@wpsantennas.com

Phone: (507)282-8484

www.twitter.com/WilsonCellular www.facebook.com/WilsonCellular

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Comentarios a estos manuales

Sin comentarios

Wilson Electronics 811201 Guía de instalación Pagina 12

Comentarios a estos manuales

Relacionado con productos y manuales para Potenciadores de la señal celular Wilson Electronics 811201