Wilson Electronics SignalBoost DT Especificaciones descargar pdf (Pagina 8)

8

Need help? www.WilsonElectronics.com Tech Support 866-294-1660

Mon.- Fri. Hours: 7 am to 6 pm MST

If possible, place the Desktop

Signal Antenna directly beneath the

placement of the Outside Antenna

location. This creates a maximized

signal zone within the room where the

Desktop Antenna remains.

3. Keep the DT and the Desktop

Antenna at least 18 inches away

from each other with the Wilson logo

on the Desktop Antenna facing away

from the DT.

4. Do not face the Outside Antenna and

the Desktop Antenna toward each

other. This can cause the DT to show

red lights and shut down, preventing

oscillation or feedback (see

troubleshooting on pg. 9). In other

words, the Wilson logos on the

Outside Antenna and the Desktop

Antenna should always be facing

away from each other.

Place the desktop signal

antenna directly beneath the

placement of the Outside

Antenna location

At least 20 feet of vertical

or horizontal separation

from the desktop antenna

is needed

DO NOT

face the Outside Antenna and

the Desktop Antenna toward

each other

Minimum separation

of 18 inches

5. If you do not know how to mount

hardware or run coax cable through

walls, ceilings and oors, get help from

one of Wilson’s certied installers at

www.wilsonelectronics.com/installers

or from a qualied contractor or

electrician. You can also try the Inside

Window Mount option (pg.5), which

may be sufcient for your needs.

Recommended: Lightning Surge

Protector (Sold Separately, part #859992)

We recommend you install the Lightning

Surge Protector (LSP) close to the

DT. Attach the cable from the Outside

Antenna to the surge protector and

ground the surge protector. The LSP is

sold separately (refer to page 15).

Ground

Wire

DT and Desktop Antenna

Placement

Important notice: Connect your DT AC

Power Supply to a surge protected AC

power strip with at least a 1000 Joule

rating. Failure to do this will void your

warranty in the event of a power surge or

lightning strike.

1. Select a location for the DT that is

away from excessive heat, direct

sunlight, and moisture and has proper

ventilation. Recommended locations

include on a shelf, in a closet, on a

desk or behind it. Be sure the location

is near a power outlet. To ensure

proper ventilation, keep other objects

at least six (6) inches away.

2. Attach the coax cable from the

Outside Antenna to the DT at the

connector labeled “Outside Antenna.”

!

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios