Wilson Electronics SignalBoost DT Especificaciones descargar pdf (Pagina 9)

9

Need help? www.WilsonElectronics.com Tech Support 866-294-1660

Mon.- Fri. Hours: 7 am to 6 pm MST

Note

Face Inside Antenna

away from DT and

Outside Antenna

3. Attach the Inside Antenna to the

connector labeled “Inside Antenna.”

4. Ensure the Inside Antenna is facing

away from both the DT and the

Outside Antenna.

5. Plug in the power supply to the DT

at the input marked “Power” (next to

the “Outside Antenna” connector).

Plug the power supply into a surge

protected AC power strip with at least

a 1000 Joule rating.

6. Check the lights on top of the DT.

Two green lights mean you have good

signal. If you do not have green lights,

see the following Troubleshooting Tips.

Troubleshooting &

Understanding Lights

The DT includes two indicator lights, one

for each band (for more information about

the frequency bands used by your cell

service provider visit wirelessadvisor.com.)

All indicator lights will be green, orange

or red.

Green indicates the unit is powered

and working properly. You always

want the lights to be green.

Red indicates the DT has shut down to

prevent oscillation (feedback).

Orange indicates the DT is

overloaded because it is too close to

a cell tower.

Note: All red light issues must be resolved

before orange light issues.

Fixing Red Light Issues

If any lights on the DT are red try 1 or more

of the following:

a) Make sure all connections are tight.

b) Reduce the gain of the DT by rotating

the gain control knob corresponding

with the red light. This is done by

turning the knob counter-clockwise in

small increments, waiting 5 seconds

between each adjustment for the DT

to reset. Continue this adjustment

until the light turns green.

Wait 5 seconds

between each

adjustment

IMPORTANT NOTE: Reducing the

gain decreases the inside coverage

area. If the amount of coverage area is

sufcient when the green light comes

on, your installation is complete.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios