Wilson Electronics 859994 Especificaciones descargar pdf (Pagina 11)

Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660

or email: [email protected]. Mon.- Fri. Hours: 7 am to 6 pm MST.

2. RED

If either of the two indicator lights on the In-Line are red, this indicates

that the In-Line has shut down on that frequency to prevent an oscillation

(feedback). First, make sure that all the connections are tight. Then reduce

the gain for that frequency in small increments by rotating the gain control,

counter clockwise, waiting 5 seconds between each adjustment for the In-

Line to reset (it may take up to 3 minutes for the In-Line to reset). Continue

this adjustment until the indicator light turns green. When you are turning

down the gain, you are reducing the inside coverage area. If the amount

of coverage area is sufficient for your needs and the light is green, the

installation is complete. If the coverage area is not large enough, it is

necessary to increase the separation distance of the antennas by moving

them horizontally or vertically farther apart, or both (see Figure 7 below).

Then increase the gain until the red light comes on and then slightly keep

decreasing the gain until the green light appears. If after separating the

antennas your coverage area is still too small, contact Wilson Electronics

Technical Support Team for assistance: 866-294-1660.

The In-Line can be reset by disconnecting and reconnecting the power

supply from the Signal Booster.

To increase coverage move

Outside & Inside Antennas

farther apart

(horizontally or vertically)

Figure 7

In-Line

Signal Booster

Inside Antenna

Outside Antenna

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Wilson Electronics 859994 Especificaciones Pagina 11