Wilson Electronics 859994 Especificaciones descargar pdf (Pagina 8)

Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660

or email: [email protected]. Mon.- Fri. Hours: 7 am to 6 pm MST.

Powering up a Wilson Electronics In-Line

1. Never point the front of a Directional Outside Antenna toward the Inside

Antenna. Refer to Figures 4 & 5 on page 8.

2. Run the antenna cable from the In-Building Signal Booster “Inside Antenna”

connector to the In-Line “Outside Antenna” connector and attach to both

connectors. Run the Inside Antenna cable to the In-Line and attach it to the

connector labeled “Inside Antenna” on the In-Line. For more information refer

to pages 3 & 4.

3. Plug the power supply into the In-Line input marked “POWER” (carefully, to

avoid damaging the center pin) and then into a surge protected AC Power

Strip with at least a 1000 Joule rating.

4. If the In-Line does not have two green lights, please refer to pages 9 & 10.

5. If you know that only one frequency band (800 or 1900) is available in your

coverage area (or going to be used), reduce the gain control on the frequency

band that is NOT in use to the lowest setting. This will reduce the power

consumption of the In-Line.

6. Using multiple In-Building Signal Boosters other than the In-Line in one

installation could cause interference to the cell tower.

7. Contact Wilson Electronics Technical Support Team with any questions at

866-294-1660 or email [email protected]. Technical Support hours

are Mon.- Fri. 7 am to 6 pm MST.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Wilson Electronics 859994 Especificaciones Pagina 8