Wilson Electronics 859994 Especificaciones descargar pdf (Pagina 3)

Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660

or email: [email protected]. Mon.- Fri. Hours: 7 am to 6 pm MST.

1. Install In-Building Signal Booster (such as the AG Pro 75™ sold separately). Use the

installation guide for the model you purchased to install.

2. Select a location to install the In-Line that is away from excessive heat, direct

sunlight, moisture and has proper ventilation. Do not place the In-Line in an air-tight

enclosure.

3. The In-Line should be placed where it can make up for installation gain loss due

to cable, taps or splitters. Optimal location is near or directly connected to the Inside

Antenna.

4. a) Connect a cable to the In-Building Signal Booster at the connector labeled

“Inside Antenna.”

b) Run the cable to the In-Line, attach to the connector

labeled “Outside Antenna.”

c) From the In-Line connector marked “Inside Antenna” run a cable to the Inside

Antenna. For more information on running cable (refer to diagrams on pages

3 & 4).

5. Before powering up the

In-Line

, verify that all cables are connected and check

that all connections are tight.

Note: Be careful when plugging the connectors in so as not to bend the center

pins on the connectors

6. The

In-Line

has been packaged with the gain control knobs adjusted to the highest

gain position. If one or both of the lights are not green (refer to pages 9 & 10).

Quick Install Overview

Refer to Installation Diagrams on page 3 & 4. Contact Wilson Electronics Technical

Support Team with any questions at 866-294-1660.

Warning: Connecting the Signal Booster directly to a cell phone with use of

an adapter may damage the cell phone and/or the Signal Booster.

1 2 3 4 5 6 7 8 ... 15 16

Sin comentarios

Wilson Electronics 859994 Especificaciones Pagina 3